Hotpoint Aquarius WMA42 Front Load Washer "wma33" Questions

overfilling on rinse and spin cycle Possible that the water level sensor which is a pressure sensor has failed You can check this out on this link below: click on Pressure sensor.

My machine won't spin. The belt is OK. Any ideas? Brushes possibly? Thanks, Ian Could be brushes, only way to be certain is to remove motor and check them for wear. Replace if less than 4 or 5mm long.

My hot point wma bearing is gone. Where to buy spare ones. Hotpoint wma33. Bearing needs replacement. Depends where you live here in England I buy from hotpoint.however its quite a big job to do also ...

Invalid friend needs User Manual for his Hotpoint 1300 Aquarius Extra WMA33. Can you please help> Hello.I can help with your request. In the browser bar type in- hotpoint user manuals In the drop down

...is a blockage in the machine,but can't find the filter the machine is a hotpoint aquarius extra wma33 which is not listed below it is underneath the washer attached to bottom of drum I have seen ...

the belt on my hotpoint aquarious wma33 keeps coming off belt keeps coming off on my washing machine Belt is not adjusted tight enough when being fitted, if no adjustment can be made by moving the ...

Hotpoint wma 34 front loader will not spin Machine works perfectly in all other respects, it is not mechanical ie bad belt, loose belt etc, I suspect either a bad motor or control issue but would ...

Where's the filter? I have the WMA33 Aquarius and was wondering if the models are the same in design, and if the filter would be in the same position? all hotpoints are the same only filter that they ...

...indicates that the sensor which determines that the door is shut properly could be faulty. My WMA33 does this occasionally. I manually push the door in and up slightly with my knee - and then ...

I need to replace the 2.5m grey overflow pipe on my Hotpoint WMA33P Any good diy store should have this. access is through bottom rear panel