Hotpoint RGB745 Gas Kitchen Range "remove oven thermocouple" Questions

...remove the oven bottom, place fingers in holes near the door, and apply pressure to slide the bottom toward the rear, and lift when the front (by your fingers) comes free. Remove completely and set ...

oven burners will not light. This is a common problem that is caused by the thermocouple. I understand that you state that the pilot is running. You should check to see if the pilot's flame is heating

I'm not sure about the oven. The oven pilot orifice may have an obstruction, or if the flame is actually normal size where it covers the thermocouple when it burns, you may have a thermocouple problem

...never worked properly, the temperature is faulty etc i now want to remove this oven and have bought a new electrical oven but cannot seem to get the smeg oven out. How do i remove this smeg

...oven goes out. I held it for 5 mins last night and it still went out. Can anyone tell me why ???? I'll give this a go! With a cooker like this, you depress and then turn the control knob, press the ...

...Oven starts fine after I replaced it (hold override for approx 10 seconds until flame holds). The thermocouple is the steel rod that is heated by the pilot flame. Remove the skirt that covers the 2 ...

...Remove the side trims from the front of the oven by removing the 4 Phillips head screws (side of the oven, and also inside - open the oven door and you'll see a couple of screws on the front edge of ...

remove the oven racks and the bottom oven floor to observe the ignitor. now turn the oven on and see if the ignitor glows, if not, the ignitor is faulty and needs to be replaced. You can enter in your

...oven to the valve (gas and thermostat), disconnect the two door springs from the burner unit, remove the screw that holds the valve, remove the two screws that hold the burner in place and simply ...

...remove the thermocouple from your oven for you, you will be able to compare it with those pictures and then ask a suitable vendor questions about inlet/outlet size and the length of the tube. I hope ...