Hitachi DZ-MV550 DVD Camcorder "remove back cover screws" Questions

...back of the barrel infront of the hot shoe you will see a small hole into the top of the camera. If you use a pen or similar device you can press the release lever to open the door manually. Thast ...

...remove go back. Also be sure to remove all screws completely. Step 1 (Front Cover Removal): Remove battery then remove top silver screw just in front of the "nite pix" switch. Then lift the DVI cover ...

...remove go back. Also be sure to remove all screws completely. Step 1 (Front Cover Removal): Remove battery then remove top silver screw just in front of the "nite pix" switch. Then lift the DVI cover ...

cover toward the top/middle. Either just blow on them or if that does not work clean them with alcohol spirit or similar, put the think back together and power up and that should do it - worked for me

...back, all I got was the blue screen. I tested the USB, SVideo, and DV outputs and got the same blue screen. After weeks of deliberating, I finally decided to try cleaning the heads and that cured it! ...

...remove the battery before continuing to put it back together again. When you're done, put the parts camera back together again and keep it. You may need it for the lens assembly (I've had grease ...

...Remove the back cover and the battery. Carefully open the camcorder by removing 7 screws. You'll see the logic board. Remove the screws holding the logic board (my camcorder had only one). Carefully ...

...back on. Should be fine. open up the front of the camcorder. carfully remove the screws 4in the front and 1 under the cap then pull remove the front cover u will see a computer board attached to the ...

...back again & again. I even tried it with different batteries & direct power but the results are same. I removed the inserted tape & tried it with new casset but no luck. With this message flashing I ...

back side. Now remove the front piece. At this point you are nearly there! Now remove the metal housing that holds the lens assembly. Once removed remove the lens assembly by removing the three screws