...pressure. We just finished replacing the control board. When start is pushed it immediately turns on the drain pump and goes to the last cycle rather than filling with water. Possibly water valve ...
...immediately starts agitating without filling with water. There is a pressure switch located inside the console. It has a clear tube running from it the outer tub. It is either clogged or you have a ...
Question about Malber Washing Machines
...immediately when a washing cycle begins, A LOT of water comes out from the front of the machine (lett top). What can i do? :( Not sure if this is the same problem but my old WD800 used to spew water ...
...immediately turned it back on. If there was ANY pressure in your system, that pressure was running the impeller backwards when you turned the motor back on and that is why the center is pulled out of ...
Question about LG Washing Machines
Pressure Switch), check whether the air hole of the outer tub is blocked, if the air hole is blocked, repair the blocked hole. (3) Does water fill even though it is not energized (power is off)? If so
...immediately drains water, and then displays PE error, check drainage system. 3. Using a hair dryer, dry out the electronics, particularly the connectors, and the pressure sensor inside the top back ...
Question about Whirlpool Washing Machines
...immediately So its agitating as soon as the water comes in? Try this put the washer into spin out cycle if it starts agitating while spinning you have a bad transmission. Also does this have a led ...
...pressure error.....thats the presure gauge needs a replacement..its situated at the top of the washer......roundlike cup with a small hose attached to it projected downward to the main drum The "LE" ...
pressure to run the wash because our older than dirt water heater was full of calcium deposits and was blocking the water coming thru nearly every entry to the house. we got a new water heater and the
immediately starts the wash without first filling with water and getting the soap into the drum. This is usually caused by a low water pressure problem.Water will take the path of least resistance and
246 questions posted
Usually answered in minutes!
49 Questions
8 Questions
9 Questions
4 Questions
