...spa light works fine but the pool light flashes like a strobe. Hayward rep says "mother board" is probably bad. No repair service available. Hayward solution: Buy a new one to replace the defective ...
Spa heater not working, display panel now reads, "water sensor opened"???? I had the same problem. The water sensor is on a pipe running into your pump. It will have a circular clamp around it. Remove
Question about Jandy Pool & Spa
What can I do to use a PCB#6474G to replace a broken PCB#8124A? My old PCB is bad from my control box.It is a PCB#8124A. I have a used PCB from a RS6. It is a PCB#6474G. Will they interchange? I ...
...working-is there a heater control somewhere? Their is a heat sensor on your pipeing somewhere. It will be in a pipe and held in place by a stanles steel clamp and have a wire running back to you ...
The pump on my EZspa will not turn on. There is power going to the control panel. the lights work. the green light for the pump is on when you try to turn it off by pressing it again. It just stays ...
...spa heater and the power to the display stoped working. check the fuse inside the control box If your 1.25 amp fuse of the control circuit board has blown, you possibly in most cases, have a bad ...
Spa works fine digital display shows nothing Sounds like you have a bad topside panel. Those always show some display unless they are not working. You will need to know the model number of the control
...box/board under the spa to a thermo-well in the side of the spa. A thermo-well is a fitting which the temperature probe slides into allowing it to read the water temperature in side the spa. They are ...
...to run. Check the relay and make sure it is working correctly inside the control box. Should have 4 screws with wires attached. Check some other forums about relay problems for the exact
2 questions posted
Usually answered in minutes!
3 Questions
10 Questions
0 Questions
1 Questions