...align the ink cartridges: Disconnect the power cord from the unit, wait five seconds, and then plug it back in. This will reinitialize the unit. Print another alignment test page. If the Press Enter ...
ink from drying in the nozzles. Figure 3: Removing the plastic tape Push the new print cartridge into the appropriate slot at a slight angle, until it clicks into place. CAUTION:Do not attempt to push
...align the cartridges. The most common reason is an ink cartridge that has one of the following problems: One of the ink cartridges is low or out of ink. Black and all three colors must be available. ...
Question about HP OfficeJet Office Equipment & Supplies
...Ink nozzles under tape The HP All-in-One prompts for an alignment of the cartridges every time a print cartridge is installed or replaced. Follow these steps to align the print cartridges from the ...
...ink from drying in the nozzles. Figure 3: Removing the plastic tape Push the new print cartridge into the appropriate slot at a slight angle, until it clicks into place. CAUTION: Do not attempt to ...
ink to align the printer )4. Could also be Hardware Issue ( Most of the time the HP Printer has life time of 4-5 years )First step, Remove all the cartridges out and clean the electrical contacts
...ink. I just had to wipe it off and it would align the cartridges. The computer makes noise when the cartridges go back to their "dock". I think their is a problem with the mechanism that cleans the ...
Question about HP OfficeJet Office Equipment & Supplies
...ink cartridge in it say to push enter to align cartridges. I push enter , it prints the allignment paper out but says it fails and to align cartridge again. This has never happened before. And when I ...
Question about HP OfficeJet Office Equipment & Supplies
...Align each ink cartridge with its color-coded slot and then insert the ink cartridge into the slot. To ensure proper contact, press down firmly on the cartridges until they snap into place. Close the ...
Question about HP OfficeJet Office Equipment & Supplies
...ink from drying in the nozzles. Figure 3: Removing the plastic tape Push the new print cartridge into the appropriate slot at a slight angle, until it clicks into place. CAUTION: Do not attempt to ...
1,882 questions posted
Usually answered in minutes!
2,817 Questions
1,223 Questions
991 Questions
857 Questions
782 Questions