Question about Washing Machines
...but doesn't stop. If the water stops when you stop the cycle, then the pressure sensor is at fault. If you need to turn the water supply off to stop it, then the water inlet valve is at
...doesn't stop filling with water The washing machine doesn't stop filling with water, and so it never goes into wash mode. Just keep pouring water into the machine. Water level sensor could be
Question about Washing Machines
...WATER STOPS FILLING DRUM THEN TURN ON ONE STOP VALVE AT A TIME TO FIND OUT WHICH ONE OF THE SOLENOIDS IS FAULTY HOT OR COLD REMOVE FAULTY SOLENOID VALVE REPLACE OR STRIP DOWN AND CLEAN OUT MUCK, 3.IF ...
...stops part way through. Many people blame the program timer for this but although it is a possible cause, there are many more likely causes for this fault. The program will stick if the heater isn't ...
soap scum stops up the plastic hose and the water level switch does not close to send power to the timer. If the plastic hose is good and the water level fills and stops replace the water level switch
...water dribbles in then it stops and starts beeping, it will fill on a hot wash but wont fill to rinse as that's th cold water. MW512 The cold water solenoid valve went out. Be sure the cold water ...
water wont start filling Hi, If your washing machine will not fill, only hot or cold will fill or is slow tofill then read these tips. I have covered many of the things that can happen inthese tips...
...the water level, small, medium or large halfway it starts to fill. When I let go the water stops filling. You need to replace the water level selector switch. You can check the part at ...
Question about Frigidaire Washing Machines
...stops part way through. Many people blame the program timer for this but although it is a possible cause, there are many more likely causes for this fault. The program will stick if the heater isn't ...
22 questions posted
Usually answered in minutes!
196 Questions
158 Questions
47 Questions
55 Questions
45 Questions