Sharp AR-M277 All-In-One Printer "clear h2 00 errors" Questions

...H2-00? u have a dirty thirmistor in fusr unit.first clean it.then do this procedure.press clear key,auto photo key,clear,auto photo key in a sequence.copier will go dead .when display goes dead just ...

ERROR SIST. [H2-00] ESTE PROBLEMA QUE PUEDE SER how do i clear h2-00 on AL- 1566

H2-00 Error Code, cant clear Hi, I recently had a technician tell us our fuser unit needed replacing on our AR-M277. Before and after we reinstalled the new fuser unit, we get a h2-00 error code on ...

...H2 00 [Content] Thermistor open [Detail] The thermistor is open. The fusing unit is not installed. Cause Thermistor abnormality Control PWB abnormality Fusing section connector disconnection The ...

H2 00 Content Thermistor open detection Details Thermistor open detection Fusing unit not installed Cause Thermistor defect Control PWB failure Fusing section connector contact failure Fusing unit not

...Hi, check harness and connector betwen thermistor and control PWB. clear the error code by using SIM 14 if all didn't work you may have defective AC power supply I hope this help H2.00. Thermistor ...

CLEAR ,AUTO PHOTO , COPIER DISPLAY DEAD 14 START KEY. PROBLEM REMOVES if code comes up again after you do this then fuser lamp needs rplaced or a fuse good luck sharp copier AR-5127 displays H2-00 how

Sharp AR-168D H2-00 error code just replaced the fuser assembly. does code have to be cleared and if so how? thank you Hi, Check http://www.copier-help.com/copier-help/ecs/sharp/ecsar161.html Thanks.

...H2-00? enter simulation: pound, interrupt, clear, interrupt, then enter 14, press start,press execute on touch screen, press ca until copier restarts, this is a general clear code, if problem returns ...

H2-00, which is your thermistor in the fuser. Open door on right, three screws hold the fuser in (hot bit), release fuser slightly, being careful as it is still connected, the thermistor is sat in the