...Remove the lower kick plate. Unscrew the two screws holding the kick plate in place, and gently pull off to remove. The kick plate is the lower outside cover of the washing machine. Place a small ...
...area as well. remove lower kick panel and lower front panel screws. remove door lock screws and wire clip around boot. remove 2 upper front panel screws. there is another wire clip around boot at
Question about Samsung Washing Machines
...remove the lower kick panel by removing the screws that hold it in place. Once the panel is removed, you should be able to see the drain filter. It's a small, circular filter that is located near the ...
Question about Roper Washing Machines
...the kick plate. Note that not all front load washers have a kick plate so be sure that there is a prominent gap between the upper most region and the small lower region being the kick
...lower kick panel and remove panel. Next, remove the 2 bolts holding the upper front panel and remove it also. Now, with the front panels removed, run the washer and look for where it is leaking from. ...
...side and gently lower the washer Remove the three hex head screws on the bottom edge of the washer kick plate with a Phillips-head screwdriver or nut driver. Pull the kick plate away from the
...Hotpoint WMA40 you need to remove the screws at the kick panel on the lower front panel by the floor, then the top cover screws are under top cover inside machine remove these and top will lift ...
...Remove the front panel lower kick plate by inserting a thin ruler between the kick plate and front panel about 4 inches from each end and lever down until it releases. 3. Remove the 2 screws at the ...
...Remove the front panel lower kick plate by inserting a thin ruler between the kick plate and front panel about 4 inches from each end and lever down until it releases. 3. Remove the 2 screws at the ...
654 questions posted
Usually answered in minutes!
249 Questions
101 Questions
108 Questions
50 Questions
52 Questions