Roper RAS8445KQ Top Load Washer "mean washing machine clunks" Questions

what is a cranking noise when my HE2 PLUS is during spin cycle? Do you mean clunking

while it is agitating there is a loud clunking I had the same problem and fixed it today. all you have to do is take a putty knife and on the front of the washer, just under the top there are two ...

...holding it balanced one of them is loose if it aint noisy with out anything in it thats good it means the band and the other brackets are fine so it must be the bracket that shook off or poss ...

...machine has all 4 feet very firmly on the floor, and I mean firmly ;-0) Doesn't matter whether it is empty or not but switch it off then- very firmly push one front corner diagonally into the ...

spin cycle extra loud grease splatters on inside of front and right side panels about one inch from bottom. Good Morning Friend, I understand that the spin cycle is extra loud in your Frigidaire ...

I have a 1997 Grand Prix GTP and I think my supercharger bearings are going bad, does that mean I have to replace the whole supercharger or can It be fixed internally? 99.9% of the time it is the ...

How do you open the top of ge washer model WJRE5500G2WW to get to the basket. It went out of balance when a load that was to big was run through and now it bangs every time it reaches spin. Then ...

...Washing-Machine/38-3-862537-/GE-Washer-won-t-spin-WCVH6800J1WW Hope this helps a bit. Hi,I've seen that problem plenty of times. That rubber strip is from the door boot rubbing the inner tub while ...

...mean stripping the machine and removing the drum from the chassis, splitting it, removing pressed in bearings and then sourcing and re-fitting new bearings. To be frank, the cost of a bearing set (if ...

machine, even when empty, has all 4 feet very firmly on the floor, and I mean firmly ;-0) Doesn't matter whether it is empty or not but switch it off then- very firmly push one front corner diagonally