valve for cleaning or replacement. Then check the hose connection on the washer - remove and clean or replace any filter found. Once cleared or replaced - reconnect hot to hot and cold to cold and try
valve control"s both the hot or cold as the machine ask's for it so what i would do is to first unplug the power from the unit and then remove the water control valve and have it tested and replace it
...valve fully closing. If you have the skills, disconnect the machine from the power and the incoming water supplies, take the top of the machine off and you should be able to work out which are the ...
...control panel and remove the solenoid in question. you could try washing the solenoid valve out and opening it by applying power to it directly a few times. I have also used some electronic cleaning ...
...clean to deliver water it has power and was working fine check the water valve (which supplies water to the unit) is open. if so, the solenoid operated valve in your unit would have failed. Get it ...
...this, you haven't seen volts on any of the valve solenoids, then you're probably into a control problem and you'll need help from someone who knows that particular model of washer better than I do.
...clean screen(s) check for screen at water valve, bad,weak or burned solenoid on water valve, replace valve, reason wash cycle is long----- water restriction during fill and rinse cycles they are ...
Question about Kenmore Washing Machines
...Solenoid valves control where the water goes and the controller and the clock sends, or should send, a signal to the appropriate solenoid at the correct time. In the case where water is permanently ...
...valve, be careful because some cycles don't have bleach available) See your operator's manual. One cycle that does you can watch is the tub clean cycle. Just press the tub clean button for about 5 ...
26 questions posted
Usually answered in minutes!
3,839 Questions
3,158 Questions
2,098 Questions
1,642 Questions
1,023 Questions