...control board if the error code (E41) still appears every time the machine is started after putting a jumper wire between the door switch harness terminals. Make sure the connectors are clean and ...
...Control board thinks the door switch is open.In the J2 plug on the control, measure voltage from the black wire to ground with power on.0 volts. Check the door strike. If good, replace ...
...control board. Professional technician will need to : 1. Is the loading door closed? No, close the door. Yes, go to step (2). 2. Disconnect the plug from J2 on the Main Control Board and check ...
...from J2 on the Main Control Board and check for continuity between the pins in the plug. Open, check the door strike. If good, replace the door switch assembly. Closed, replace the Main Control
...control board; if yes Change the board E90 = Communication error between user interface and main board. Verify the connector between the main board and user interface board by plugging and unplugging ...
...J2 of control, replaced control same code persists. Could it be the door lock/switch with good voltage? check to see if the door stike is not broken on door if good and you have changed door lock asm ...
Question about Frigidaire Washing Machines
...control board thinks the door switch circuit is "open" - you would need a professional to . Is the loading door closed? No, close the door. Yes, go to step (2). 2. Disconnect the plug from J2 ...
Question about Frigidaire Washing Machines
...control board or the door strike plate and door lock switch. Take off the J2 plug from the control board and check for continuity between the black wire and ground. If you see 120V, then replace the ...
...control board.) The PAU simply indicates the control thinks it has been paused...that may be just a side affect of the door lock assembly. Here's how to check... **Unplug the unit from the wall ...
421 questions posted
Usually answered in minutes!
237 Questions
124 Questions
99 Questions
84 Questions
64 Questions