...3.)switch jp1 to clear ( the jumpewr that clears the bios is called jp1 its located close to the battery and it has 3 pins and 1 jmper) the pin set will be on 1 and 2 , simply set it to 2 and 3) 4.) ...
...as usual, but was unable to access BIOS. Was there an original modification I do not know of? [email protected] where is the jp1 ( that have 3 legs) i.e. bios jumper pins. insert the jumper 1,
...3 then replace it to i and 2 .. the jumper is jcmos 1.. or jp1 the second is unplug the system remove the side panel to open the case locate the battery on the main board remove the battery press and ...
...jp1. usually the 1-2 pins are the normal operation, 2-3 pins to clear. Please notice that no power supply needs to be connected to the computer at he time of clear! Bios clear takes abaut a half ...
...Jp1 or JBAT jumper located on the board. Its a 3 pin jumper currently set to 1 and 2,,, set it to 2 and 4 wait a few then set it back to 1 and 2. If you cant find the jumper or that fails then Locate ...
JP1 1-2* 2-3 VGA Interrupt Enabled VGA Interrupt Disabled JP2 1-2 2-3* Wake-on LAN Active low Wake-on LAN Active high JP4 1-2, 4-5 2-3, 5-6* Audio Line-in Source - AMC connector Audio Line-in Source -
...JP1) you have to make sure that you returned the jumper over pins 2-3 and not 1-2. I placed a motherboard manual online so you could check. Get it here: http://thewhiteaussiepack.org/down/k7s5.pdf ...
Question about EPoX Computers & Internet
...Jp1 or JBAT jumper located on the board. Its a 3 pin jumper currently set to 1 and 2,,, set it to 2 and 4 wait a few then set it back to 1 and 2. If you cant find the jumper or that fails then Locate ...
...jp1 or jcmos. Its currently set to 1 and 2,, set it to 2 and 3 ,, wait 10 seconds the set it back to 1 and 2 2.) locate the battery on the main board, remove it.. Its held in place by a pin, just pry ...
...3 bare. It will be marked JP1. Move the jumper to cover pins 2-3 instead. Leave in this position for about 30 seconds, then return the jumper to its original position (pins 1-2). 6) Reconnect the ...
49 questions posted
Usually answered in minutes!
1,358 Questions
703 Questions
590 Questions
517 Questions
494 Questions