Honda Eb 3500 Generator "idle down working" Questions

...idle down when not powering anthing Most generators will run at full speed when started. Verify in the owners manual if Your generator has an idle control setting. Even so, as soon as you plug ...

...I choke it i can get the generator idle to go down. If I turn off the idle control the unit will try to compensate. Any ideas? check to see if somthing is blocking the movement of the govenor ...

...the engine from low speed. Some of these set ups don't work well if the idle is turned down too far so that's why I suggested trying that first. Plus is that works it is a cheap

...idle down or does it start at idle? If it starts at idle, or seems to idle down faster than usual, something might be amiss in the works. 2 - When you turn the idle control switch to "off" does the ...

...down unit. That is with no tool in use, just plugging into the receptacle. Hi. There are 2 things that control the Auto Throttle and that is the idle control valve (Connected with black and yellow ...

...down, then your auto throttle is working. when you hit the switch watch the throttle arm move on the carburetor to the idle position,if so you may have to clean the carburetor jet and fuel nozzle ...

down time. Afterwards I changed the oil (replaced with honda oil) and started it as usual every month for aprx 15 min run time. recently I had to change the fuel to fresh since it has been sitting for

idle. If you shut it off for a few minutes it will work just fine for a time them repeat the cycle. The oil level is perfect. Air filter perfect. The unit is perfectly maintained. I had this happen in

...idle down. As it tries to rev up a second time, it dies. This happens with or without a load. When the covers are off and watching the side of the carburetor you can see the throttle stop move far ...

...idle switch with no load connected to the generator the engine down its speed but not constantly. Its start increasing and decreasing its speed and did not maintain its lower speed as is supposed to ...