Generac Generator 15000 Watt 15kw "test output motor" Questions


...output. Brushes are fine. Does anyone have a test procedure for testing Field excitation. Also would like to find a manaul for it Check the voltage sent to the field when running. It will probably be ...


...output fuse or circuit breaker? If you can check for voltage directly from the stator or armature and check the results. Nothing? If it has them, could be brushes. Also, if it's a fuse, don't just do ...


...test is to just see if there is output at the power wires that go to the transfer switch from the generator. The thing you don't say that ought to be happening is that the control board should crank ...

MOTOR RUNS FINE IT PUTS OUT 110V BUT AFTER 10 MIN 0R MORE WILL DROP DOWN TO 90V Much will depend on the design of the alternator and how the rotor is energised and/or how the output is controlled. ...

...output. I tested the voltage with a Fluke volt meter and it showed 240 Volts+ then lowered the RPM and it then was putting out around 119 Volts. It seemed to vary directly with the RPM. Is my voltage ...

Question about Generac Electrical Supplies

1 Answer

output? Has less than 150 hours although 11 years old. Motor runs great propane but shuts off every 15-18 seconds. Checked murphy switches oil & temp and they are fine. Notice generator is not putting

...output starts all over again. The green light remains on throughout. This fault is apparent with or without the smart switch on, I have checked the stepping motor and this seems fine. This fault does ...

Question about NEC Electrical Supplies

2 Answers

can say it would seem the engine rev has a lot to do with the output. Hey if you think theirs a problem take it to the sparky get him to test it, Don't do it yourself we could be talking life or death

Question about Coleman Electrical Supplies

1 Answer

...output. Brushes are fine. Does anyone have a test procedure for testing Field excitation. Also would like to find a manaul for it Well, its not exactly a published procedure, but this is what I would ...

Question about Generac Guardian Electrical Supplies

1 Answer

output of the charger with a DC voltmeter. Simply press the test leads to the battery posts and some value above 11.5 volts (11 - 12.75 volts may not be uncommon).  Look at the chart below to get

Not finding what you are looking for?
Generac Generator 15000 Watt 15kw Logo

2 questions posted

Ask a Question

Usually answered in minutes!

Top Generac Electrical Supplies Experts

Bill Johnson

Level 2 Expert

306 Answers

Fahr Quad

Level 3 Expert

774 Answers


Level 3 Expert

2601 Answers

Are you a Generac Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides