...point IRE calibration IRE: [Red, Green, Blue results, respectively, for each IRE point] 100 [50, 40, -50] 90 [1, 33, -50] 80 [9, 32, -50] 70 [-3, 6, -48] 60 [-1, 4, -34] 50 [-4, -4, -38] 40 [-5, 0, ...
Sky+ remote control codes then press the Select button. The red light at the top of the Sky+ remote control should flash twice. 5* Point the Sky+ remote control at the TV and try the volume button. OK
...red green The microprocessor is not receiving a "Hand Shake" from another part of the set. Check that there are no open circuit fuseable resistors, (if there are that will point you to the problem) ...
...red as well. What do I need to do at this point? Who do I need to call to fix the issue? if the lamp light is flashing u need to replace the lamp. u should have instructions on the set or in the ...
...red light on my TV. It will not turn on. No power light is on. Any suggestions. I would appreciate. The inverter board is damaged at this point. you will need to replace this failed board in order to ...
...light Mine too. I pushed and held the power button in at which point the red light turned off. I then pushed the power button and the tv came on and is working fine. I hope this helps you. Good
...red headphone (it works point-to-point ) you will hear the voice of TV, than adjust volume properly...Thats it..now lets go to second step.. Your headphone's Base should either "3.5mm stereo ...
Red pin being the bottom most. If its 5 pin connector, then start from the lowest point on the back of TV. If its 3 pin connector, use the top 3 points, on back of your TV. Red always being the bottom
Question about Insignia Televison & Video
...test points, but was unable to get a reading at a 7 Vdc test point. Power LED is off, showing no light (red or blue). Board is shot. Unless there is a cylinder fuse on board....but probably
14 questions posted
Usually answered in minutes!
43 Questions
5 Questions
14 Questions
13 Questions
9 Questions