Pyramid Cdr22kit Am-fm Receiver Cd Player With Full Detachable Face "change amp radio controls" Questions

...amp Yamaha has come out with. I have my surround hooked up and everything is working great and sounds great!! HOWEVER I have preset my radio stations manually and am hoping to be able to change from ...

...radio on & off a few times and the same - left for 10 mins then OK. This is intermittent but seems to be happening more and more. Any ideas Most of these things use an IC to control things like ...

...of output tubes and the output tubes matching trimmer if your amp have it.then check change the volume pot.then check the ceramic capacitor i n the input of the last 12ax7 tube in the power amp

...amp;#39;t start Airplay when it is fresh connected to the net, it will newer show up as a device. However, I can always play internet radio and control i from the phone, so the network connection is ...

...change mode, etc.). Generally speaking, an amp protects itself from heat, shorts and overloads. Overloads can be from excessive periods of high output and shorts would be wiring issues or a speaker ...

...amp and see in the speakers come on.If so theres a problem internally in the radio itself.I hope this helps you and Have a great day and will answer anything else you may have I would trace all the ...

...amp block is held in by six screws. first remove the cross bracket, then cut the cable tie free from the hole on the board. Ten screws hold the top board on, the pull the boards apart from the ...

...radio. AVR has been disconnected. TV sound system is being used. Does this sound like a power supply capacitor problem? I can replace capacitor(s) or other componets. I just need to know which ones. ...

...change the volume level every time I press the remote volume button. Any ideas what's going on? the circuit of the device gets heated and board acts as it hanged and the device reacts like this.just ...

...change and you will suddenly release the amp's full power and possibly destroying your speakers. If a signal isn't audible at 1/2 volume it's probably not there. Carefully examine the ...