...three pins 2 at a time with an ohm meter. You should get readings all the way around. Then test 1 pin at a time touching the other probe to the copper on the outside the compressor. Tell me what you ...
Question about Kenmore Refrigerators
...three wires on the relay. This compressor is on a Kenmore refrigerator, model 795-71022-011. The PCB is giving me an LED code for Piston Lock. I would like to test the compressor before replacing the ...
...three pins on the compressor and the device has three holes in it,you line up the holes and push the device onto the pins and to remove it pull back on the device to slide it off the pins,the easiest ...
...to check the pins, between any two of the three pins you should get a read of 5 to 6 ohm, anything over 10 ohm is shorted out, higher values about 5 or 6 may indicate certain failure is going to ...
...three teminals if one shows nothing the internal bi-metal overload is open due to hard starts. Make sure the power is off when doing this and the wires are unpluged from the compressor pins, there ...
...three pins on the compressor have continuity with each other. I also checked the pins for continuity to the compressor case and it gave me an OL for each pin. I took an ohms reading for each pin and ...
Question about Refrigerators
...three contact pins, one pairs resistance will be higher than the other. Then check from each pin to the a clean metal part of the housing, there should be not circuit on any pin, if there is its ...
...three pins on the compressor what goes where The start component assembly goes to the three pins. You have to have this assembly. Always shipped with a new compressor. The 2 wires go the start kit, ...
Question about Refrigerators
...three pins of the compressor and there's a certain place that they go they got one on each pen must be the correct pin now you're talking about two extra wires those are what connects with the power ...
Question about Maytag Refrigerators
...three pins on the side of the compressor is burnt off. Is it worth repairing? Would the compressor be covered under any kind of warranty or recall? It is over 10 yrs old Probably not. Sounds like ...
8 questions posted
Usually answered in minutes!
60 Questions
33 Questions
29 Questions
19 Questions
17 Questions