...connect to the Sitecom WL-130 from my laptop, but it doesn't seem to be able to talk to the router correctly, and when I try to connect to the internet, I get "Page can not be found" and "Limited ...
...It worked fine until I added a passkey to the main router (WPA) and to the Sitecom. It still connects, but has a habit of dropping the signal. This can vary from constantly to keeping the ...
...sitecom 300N lose its connection to BT homehub 2. Why does the config backup/restore not work 3. Why can I only connect a PC (wired) to the 300N in its vanila factory settings state. Once I have ...
...connect a sitecom 300n(wl-330)but cannot get an internet connection the router is an Orange livebox you need to put in the connection tab the name of the router you are trying to get in to and the ...
My Sitecom 300N regularly loses its connection to my Cisco modem..... it is usually only a (fraction of a) second or so and does not harm internet browsing etc... However, when usinf e.g. Skype in a ...
...where there is a good signal from the Router. However, I'm not experiencing any improvement in connection strength from the Repeater whether it's switched on or not. Where might I be going
connect the Sitecom using the wire (UTP). You should be able to browse with an internet browser to 192.168.0.234 now. After setting up the Sitecom disconnect the wire and enable the wlan adapter again
connect up with my Embarq wireless router, but once again the signal is very low at the distance I am trying to use it at. when using the range extender you have to make sure you set the SSID, channel
...connect to sitecom device. - you may have to manually set your IP address. (from network resources control panel, TCP/IP tab. Check the istructions, cause you have to choose an address in the same ...
61 questions posted
Usually answered in minutes!
1,082 Questions
984 Questions
709 Questions
641 Questions
532 Questions