Xerox Phaser 7750 Laser Printer "error check unit" Questions

error still occur? Go to step 3. Complete. 3 Check the wiring harness connectors P/J40, P/J41, P/J411, and P/J412 between the MCU Board and the Laser Unit. Are the connectors securely connected? Go to

...Error 33 Check for jammed paper throughout the paper path (especially in paper feeder). Remove and re-install the paper feeder and Transfer Kit. Turn the printer off, then on. Error 40, 41, 42,and 43 ...

...error. Initial Actions: ? Check the condition of the Transfer Unit drive gear. ? Cycle the printer's power. ? If the problem persists follow the procedure below. Troubleshooting Procedure Table 1 ...

error couple of weeks ago on my 7300. I did everything you did and nothing so I ended up visiting www.iteminconline.com. I called them up and they told me to check all the cables on the engine control

...error will persist until the unit is replaced with a new one. Is the the imaging unit an OEM unit or remanufactured? Whoever you got the unit from should replace it as defective free of charge. If it ...

error Temperature of the Fixing Assembly did not reach the specified temperature within the specified period of time. Remedy1. Check connectors on the fixing film unit. 2. Replace the fixing film unit

...error code 941 on a Xerox Phaser 7400? www.support.xerox.com -phaser 7400- support -fault code-941 says cyan or magenta toner failure, but the solution says to 1. remove & reinsert the cyan or ...

...error 73 Follow these steps : Do power cycle Turn the printer off, wait approximately 30 seconds and then turn the power back on. Reseat the Imaging Unit Unscrew the two blue screws on the Imaging ...

error no luck so far, can anyone help me Replacing the fuser will fix that. Or if you want to strip it down check the lamps and if they are ok change the thermistor and thermostat. But your better off

...check all connections to the laser unit and cycle the power (turn the machine off and on) if error continues replace the laser unit. You can buy a replacement for $350 new or $225 refurb. Part# ...