...see if belt has slipped Camshaft setting tool put in position(rocker cover off) pump locking tool inserted, top dead center mark on flywheel in correct position.if not correct something won't line ...
...correct sequence using 2 steps, as follows: Step 1-30 ft-lbs (40 Nm) Step 2-tighten an additional 90 degrees Position the crankshaft keyway in the 11 o'clock position. Lubricate and install all ...
...correct crankshaft position. Remove the special tool.NOTE: Crankshaft sprockets are identical. They can only be installed one way. Refer to the following illustration for correct crankshaft sprocket ...
position. For the Camshaft gear, the small hole under the " 4A " on the gear should line up with the indent on the front camshaft bearing cap. The approximate correct oposition of the camshaft gear is
Question about Seat Alhambra
...correct position. Check this...Fig. 1: Timing marks are located on the camshaft pulleys as shown-1.8L enginesFig. 2: Make sure that the crankshaft sprocket (timing belt pulley) and oil pump timing ...
...correct (second) notch in the pulley is indexed to the lower cylinder block. Position the crankshaft just prior to top dead center. Remove the bolt and install the TDC peg. Rotate the crankshaft ...
...to turn each camshaft pulley 3 to 4 complete turns before they will align in the proper position. This is your correct timing. I hope this helps you, and I would appreciate your feedback and
...position the oil pump and camshaft sprockets with their timing marks to line up with their respective marks on the inner cover. Install the belt and release the spring tensioner to let it adjust ...
correct timing. If the camshafts are out of position and must be rotated more than 1⁄8 turn in order to install the alignment dowel pins, proceed as follows: The crankshaft MUST be rotate 90
...correct installation, turn the crankshaft until the camshaft sprocket timing mark is approximately at the one o'clock position, then count the number of chain link pins between the points shown ...
14 questions posted
Usually answered in minutes!
11 Questions
7 Questions
5 Questions
3 Questions
0 Questions