1995 Mitsubishi Lancer "fuse need replace tail lights" Questions

...need a fuse diagram for my car please There are 2 lots of fuse boxes on cars, one in the engine bay and one normally by the drivers door or just under near the drivers knee... This is where the fuse ...

...out. which fuse do i need to replace? parking light fuse,tail light fuse,and dash light fuse,need to look at the car manual, it will tell you the three fuses to replace, to get your lights back ...

fuse can cause it to blow. To troubleshoot the issue, you can start by checking the wiring for any damage or loose connections. You should also inspect the tail light assembly for any damage or issues

...replace if out. If fuse continues to fail, check the tail light or side globes for a faulty globe and replace if necessary. Also check for any chafed wires that could be shorting to the body causing ...

...NEED A LITTLE GUIDENCE TO THE TAIL LIGHT FUSE. THANKS You should have a fuse panel under you dash inside. This is where the fuses are located for lights. Don't know the exact location, but you can ...

...fuse will fry too. Follow the procedure to replace tail lights in ur lexus. Engage the parking brake and turn the ignition key to the "OFF" position. Open the trunk to remove the trim cover and the ...

...FUSE OKAY.CLUSTER MORE LIKELY NEED REPLACING.REPLACE REVERSE LIGHT BULBS.CLEAN BULB SOCKETS USING ELECTRICAL CLEANER.IF BULBS STILL DONT WORK.TRANSMISSION NEUTRAL REVERSE SWITCH BAD.TAIL LIGHTS ...

Need to install resistors for hyperflashing signaling. when there was no fuse, blinkers worked; not functioning with a good fuse. With a good fuse, left tail and license plate light works, not without

...the problem lies near the dash because dash,tail,and license plate lights work on same circuit IF THE FUSES ARE GOOD THEN YOU NEED TO REPLACE THE HEADLIGHT SWITCH. Check/replace tail/parklight

need someone who can,like a repair shop TAIL LIGHT NOT WORKING It can be faulty tail light bulb or its issue with tail light control switch or its wiring's are short. Check the voltage at fuse slot of