Markbass Standard 104HR Rear Ported Neo 4x10 Bass Speaker Cabinet "impedance measurements" Questions

...Checked - there is no battery with this instrument. The piezo pickups for violins REQUIRE a high impedance input preamp. The measured impedance of My wife's violin is on the order of 2 megohms. It ...

Roland AC-60 Amp input impedances ? What is the input impedances of the guitar channel ( for both Piezo and Magnetic inputs) and for the Line and Mic inputs on channel 2? Why Roland doesn't publish ...

...into the old setup for best vocal sound. Am I missing any device(s)? Thanks in advance Watch your impedance, when you add speakers the impedance will change. example 8 ohm speaker placed in

whats the ohms of the individual speakers in a markbass standard 104hr 8ohm cab? The Ohms for individual speakers is measuring the impedence of that speaker and NOT the pure resistance.  Speakers

...pins 2 and 3 of each mic connector when measured to pin 1 of the connector. There is about 6K ohms impedance from the phantom supply to pins 2 and 3. IF you have an accident and connected high ...

...for RMS power is designed to be able to handle the heating caused by the resistance of the wire and impedance of the voice coil winding for that rated impedance.  Say 4 Ohms- this is a nominal ...

sure the wiring is still connected to the speaker and if you have one, try measuring the resistance(impedance) of the speaker with a volt ohm meter.Do this unplugged from current and disconnect one of

...try connecting speakers to another sound source or if you have access to a ohm meter, check impedance of speakers, should measure 4~8

...voltages, put an audio source on the input and set up a headphone with test leads, or better- an impedance matching transformer with test leads on the high impedance winding- put one to ground, ...

...than the diode being bad itself. The scanning is of a conductive rubber key contacts so is high impedance as the contacts don't go near zero ohms when pressed. Leakage in the diodes can cause the ...