...Then I striped the wires. But I noticed that there were only 4 wires, yet there were 5 places to solder. Looking at the part, There are 3 connected wires that I have not cut off yet and there is 1 ...
Question about Parrot Radio Communications
...parrot? 0n line tech.service - said they only handle computer related problems My guess is that the soldered piece broke? Does it look like it can be re-soldered? If so, do u have any friends who are ...
Question about Slider Radio Communications
...enameled wire, which are red and green. These cables need to be stripped back before they can be solder or put together. Try scraping the ends with a sharp knife or with actual cable stippers. The ...
Question about Motorola Mobility Radio Communications
...I cant find a replacement part. Can you tell me what to order or get one from? You would have to solder the wire together and get some electrical tape to put over it, but overall if it was not too ...
...your waranty so try this at your own risk). If it is out of waranty and you have experience with a soldering iron, the earbuds can be replaced with a plain set that look similar to the originals
Question about Logitech Radio Communications
...to repace You will have to buy a USB connector cable and cut off one side. I hope you know how to solder. The USB cable is very cheap, and if you know how to solder well, your problem is solved. hi ...
...repair my HS-23 stereo headset had accidentally got plucked off and totally disconnected from the soldering of the middle section. I checked all the wires in the headset using continuity tester and ...
...circuit exhibits high resistance due to a microscopic gap opening up in a component or a defective soldered joint. If removing the jack plug and replacing it clears the fault for a while this ...
...headphones fell to the floor and a connection on the right side broke (a wire disconnected from the solder). I tryed too re do the connection with my soldering iron but I cannot get it to work, check ...
Question about HP Radio Communications
...a open in the wire somewhere I'm not sure what you mean by "I checked the cables and they're still soldered" - soldered to what? There are going to be at least two solder points for each cable: one ...
5 questions posted
Usually answered in minutes!
129 Questions
74 Questions
56 Questions
47 Questions
18 Questions