...belt position detection abnormality (Normal speed) If the error [CEE0] has occurred, check the transfer belt home position sensor-1. If the error [CEE1] has occurred, check the transfer belt home ...
Question about Toshiba Office Equipment & Supplies
...belt position detection abnormality (normal speed): The home position of the transfer belt cannot be detected. This likely means that your transfer belt has gotten ripped. There are reflective strips ...
Question about Sharp Office Equipment & Supplies
...belt position sensor is not interrupted or it is always interrupted. Belt separation clutch operation trouble Check and remedy Use SIM6-3 to check the belt separation operation. Case 3 Cause The ...
Question about Xerox Office Equipment & Supplies
Belt Position Monitoring Description Belt Home Position too long Initial Action NOTE: If this fault is declared 3 times in succession, the print mode will be disabled. In order to clear this condition
belt position error. Either the sensor that detects the position of the transfer belt is defective or the drive mechanism that that controls the position of the transfer belt is defective. Cleaning of
Question about Canon Office Equipment & Supplies
...belt home position sensor is faulty. Condition 0001 The knurled belt motor does not return to home position when the knurled belt motor is driven for 1 sec or more. 0002 The knurled belt does not ...
Question about Xerox Office Equipment & Supplies
i Have a subsystem fault 004-332 on a xerox 2045. Any ideas? 4.332 belt position failre as you can see the belt edge sensor sa detected that the drive belt is out of its position.
...yep! e3-80 machine error has something to do with home position of the intermediate transfer belt. possibly the home position sensor is dirty or the belt itself, the home position guide is damaged.
Question about Canon Office Equipment & Supplies
...belt has failed once. ITB home position sensor B and ITB home position sensor A must occur alternately; however, the same state has been detected continuously. Turn off the main power, and check the ...
...Sensor does not detect the Transfer Belt position detection hole a second time even after the lapse of a predetermined period of time after it has detected one while the Transfer Belt is
674 questions posted
Usually answered in minutes!
436 Questions
284 Questions
267 Questions
262 Questions
214 Questions
