...power coming in to the unit. If you are using a surge protector or UPS unit, Plug the unit into the wall and power up the printer. If that does not work, then: PEST Fault 37,004.40: xxx Printhead ...
Question about Xerox Phaser Office Equipment & Supplies
...Unit Polygon On power up get the message "Laser Unit Polygon Motor Failure". What part died now? That means that the Laser Unit is bad. I have fixed that error, by tahking the Laser Ubit's ...
Question about Xerox Phaser Office Equipment & Supplies
...orange protective cover out and then down from the top, center of the Imaging Unit. Close the Front Cover. Power ON (') the printer. A 'Ready to Print' message will be displayed on the Display
Question about Xerox Phaser Office Equipment & Supplies
...IMAGING UNIT.Close the door and Power On.Msg gone? If yes, replace IMAGING UNIT.If no, remove the FUSER unit.Close the door and Power On,Msg gone? If yes, replace FUSER.If not, it is the ENGINE
Question about Xerox Phaser Office Equipment & Supplies
...Unit. Go to step 2. 2 Cycle the power. Does the error still occur? Go to step 3. Complete. 3 Check the wiring harness connectors P/J40, P/J41, P/J411, and P/J412 between the MCU Board and the Laser ...
...power back on. Reseat the Imaging Unit Unscrew the two blue screws on the Imaging Unit (one in the upper-right corner and one in the lower-left corner) and then turn the blue, bottom lever ...
Question about Xerox Phaser Office Equipment & Supplies
...Unit.Cycle the printer's power.after these steps it gets a lot more detailed and you would need to be an experienced tech to understand everything and follow the steps within a timely manner, if ...
...unit failure. For some reason, your laser assembly has failed to power up properly. One reason could be that when installing the new yellow cartridge, you may have dislodged a connector to the laser ...
Question about Xerox Phaser Office Equipment & Supplies
...is that your printer is not getting enough power, verify that there are no external power supplies, or extention cords connected to the unit, also, you might want to try another power plug. ...
Question about Xerox Phaser Office Equipment & Supplies
...unit was plugged into a power strip for a couple of weeks before this condition presented. Other identical units plugged directly into a wall ac outlet are still working fine. All units are same age. ...
6 questions posted
Usually answered in minutes!
436 Questions
284 Questions
262 Questions
152 Questions
147 Questions
