...double sided tape. This will do for now until I can learn more about the repair. got to mention there is a tech note on this I heard and it talks about a "bounce" of the flag sensor and a time out ...
Question about Xerox Phaser Office Equipment & Supplies
getting an error mssg E3 after removing jammed paper fro my MP160 printer. Thks, Andr? As you will probably know E 3 on Pixma is paper jam. Double check that there is no paper inside, and turn printer
...Pick up rubber (top and bottom) has grip. You can buy a set of paper feeder about $25, or maintanenance that. Just add tape (double side tape) under rubbers. And check lubrication at paper
Question about Xerox Phaser Office Equipment & Supplies
...paper jam in scanner document feeder. I have the same all-in-one printer and have just recently, the unit is a few years old, started having the same problem. I found that that if I make double sure ...
...paper dust. A quick way to double check this is to power cycle the printer & try to print from Tray 1, the MP feeder tray (unless Tray1 has rarely or never been used...it might be a little ...
Question about Xerox Phaser Office Equipment & Supplies
...double sided the printer always errors with paper jam 1, even though the paper hasn't jammed. After printing the first side of the paper, the paper appears in the output tray, and is then taken back ...
...getting paper jam error message after I try to print on photo paper Some printers detect the type of paper you are using, and print accordingly. Do you have photo cartridges installed? If not, that ...
...double-udouble-u dot brianbell dot net for more information. I would recommend buying replacement flashrom from Sharp (if they still have them) or getting the most current version from a dealer. Not ...
...paper comes from. If you get a torch or light and look inside you will see two leavers (one double leaver and one single leaver). The single middle leaver is your problem, it senses to see if the ...
Question about Xerox Phaser Office Equipment & Supplies
...getting the "Media Out" error when i tried to print it using the sheet feeder. It turns out that by puting a few blank sheets under the one I was using it lifted the paper enough so that it sensed it ...
175 questions posted
Usually answered in minutes!
436 Questions
284 Questions
262 Questions
147 Questions
158 Questions