alcohol The encoder on the end of the drum assembly is contaminated with the lubricant from the maintenance kit. You need to remove the right side cover, looking from the front. Look at the end of the
alcohol) and a lint-free cloth or cotton swab, then reinstall the cartridge (clean the cartridge-side contacts as well). If it still does not work, could be the contact ribbon wire which got loose, or
Question about Zebra Office Equipment & Supplies
...side with a little alcohol to eliminate any contaminents that might be present to hinder connectivity. The last suggestion is to use a piece of paper with some rubbing alcohol on it and touch it to ...
side so that it does not block the ribbon sensor.After pulling the ribbon away from the sensor, CLOSE THE PRINT HEAD.Hit Continue.It will now say CALIBRATING PLEASE WAITIt will
...side door. About midway down you will see an opening with a very fine wire in it. That is the wire responsible for transferring the ink from the drum to the paper. Dampen a Q-tip in some alcohol, and ...
side so that it does not block the ribbon sensor.After pulling the ribbon away from the sensor, CLOSE THE PRINT HEAD.Hit Continue.It will now say CALIBRATING PLEASE WAITIt will
Question about Zebra Office Equipment & Supplies
...side of printer the error light flashes in sequences of 2 before a pause. print head screeches when it gets to the left and then it sticks first of all please turn off the unit....unplug the power ...
Question about Samsung Office Equipment & Supplies
...side in the gray waste toner tank. You can pull it out and replace it with an empty one or you can try to empty it and reinstall the tank. If you empty it, you have to make sure the parts of the tank ...
...side and I got the 5100 error. I turned off the printer and disconnected the power. I took a flash light and carefully inspected the clear ribbon. In the middle there was a bit of goop on the clear ...
Question about Fargo Office Equipment & Supplies
alcohol drip inside the printer's case. As an alternative method, use a can of compressed air and in a sweeping motion blow air into the printer from the card hopper working towards the card exit side
264 questions posted
Usually answered in minutes!
402 Questions
235 Questions
259 Questions
211 Questions
166 Questions