Question about Behringer Music
...wire mixer to eq to amp Line level output of the mixer would go into the line level inputs of the EQ, and the EQ line level outpputs to the line level inputs of the amplifier. If you are faced ...
...1/8" end goes into my line in on my sound card. (not the microphone in ). The RCA jacks are hooked to two cords that I made up that have a RCA plug on one end and a XLR plug on the other. The XLR ...
...1/4" "Phono Plug" - a super common connection for audio gear of all sorts. The crackling sound is from the connection between the plug and the jack (being broken) and the amplifier amplifying the ...
...1/4 jack? Thanks Belvidere Park Sound and Light What you are requesting will not work as you expect. The easiest way to achieve what you seek is to utilize what is called a Direct Box. This is ...
Question about Behringer Music
...wire balanced 1/4-inch from the 802 to the left and right inputs of the interface (XLR Male), then RCA (Red and White) to a 1/8-inch TRS Plug cable onto the the computers audio input. Henry ...
Question about DIGITECH Music
...1/4 inch guitar jacks or the XLR? Is the XLR wired correctly? If not it may be grounding out the input.If your eurozone power pack is the correct polarity on the coaxial power plug, the unit ...
...wire is firmly attached at both ends of the power supply lead. Could be a defective mains socket - try plugging it in to a different one, preferably on a totally separate circuit. Could be an earth ...
1/4 inch jack by wiring it to swap the tip and ring between them to use for connecting to the emgs guitar. ALSO verify you are using the SAME type guitar cable for both.OFTEN a TRS cable will NOT turn
wire plugs, then you need to get an electrician to install a grounded receptacle. 2. Use Balanced lines. This means XLR or TRS balanced cables between the piano and the speaker. Use the 1/4 inch jacks
4 questions posted
Usually answered in minutes!
192 Questions
108 Questions
85 Questions
69 Questions