jumper setting (Master, Slave or Cable Select). Then look again the rear side of the HD and u will see some pin that locate beside the power input of the HD, that is the jumper pin. Now set the jumper
Question about Quantum Fireball Computers & Internet
...jumper setting following the SLAVE DRIVE - Jumper stored in parking position setting (PK). the yellow colored block is the jumper pin, positioned 2nd column in the jumper connector. Thanks for using ...
jumper setting so that if "Jumper 50" is set; the two pins farthest from the power jack, is Master Drive. No pin jumper set, Slave or Cable Select. I hope this helps. I posted earlier for someone else
...jumper out. only use the "slave" setting if the "master" device on the same ide cable is actually set to "master". if the master device is actually set to "cable select" then you will have to set the ...
Question about Quantum Fireball Computers & Internet
...a PC. You want the drive to be the slave drive, and you know what that you must change the current jumper settings. The four jumpers on the drive are labeled DS, CS, PK, and Rsvd. The description of ...
Question about Quantum Fireball Computers & Internet
...to farmat it frist how do i add the 20 G.B. quantum fireball HD to my coputer and how do i set the jumper If I recall right this HDD is a PATA (IDE) type. As for the Jumpers please check the ...
jumper setting what are the jumper setting for a maxter quantum fireball plus as20.5-gb hard drive so its the slave Jump the middle pins, second set from the right when looking straight on with the ...
Question about Quantum Fireball Computers & Internet
...a boot up message stating "primary Hard drive 0 not found". In the Bios, it is listed as "unknown". Jumpers set on CS, but tried Master too...the maddening thing is that when I slave this HD to ...
Question about Quantum Fireball Computers & Internet
How do you set the jumpers the Maxtor Quantum Fireball Plus AS 20.5 GB hard drive Jumper settings for Seagate and Maxtor IDE (ATA) harddrives, ...
wanting to use as slave hard drive i need to know what jumper pins i need to cover or pull out hi ronrayhall, I installed a maxtor hard drive, and they are shipped with a default of cable select. If ...
33 questions posted
Usually answered in minutes!
13 Questions