red ANT light i can move my ANT coax on the back of my radio and it cuts the light on and off. any idea what this means This is telling me that there is possibly a problem within the PL 259 connector
...red ANT light on my CB Just bought brand new Cobra 29 ltd Black Chrome new antenna new mount and cable. Everything new and getting red lights on both Ant and RX/TX. Tried the other antenna I had ...
...ANT light is red when your SWR is too high (over 3) 1. turn the knob labeled swr cal all the way counter clockwise 2. set the rf swr cal switch to the CAL position 3 key up the mic and hold it while ...
...red "ANT" light comes on when I key the mike even though it's hooked up to a good antenna. I also calibrated the mike to the meter. Any suggestions? if the red ant light comes on this means that you ...
Question about Radio Communications
...red light.I have a galaxy979 and a no ground ant there are two lights on the face of that radio near the channel selector.When you turn the radio on the top top light should be a greenish blue until ...
...red ant light come on when I key the mic is that ok? if its the AWI light then you have an antenna problem.Most likely a mismatched antenna.get a good match,under 2.5 and you should see the light go ...
Question about Cobra Radio Communications
...red ant light supposed to light up when the mike is keyed or only when there is something wrong? only when something is wrong, probabley too high of SWR If the radio has been paeked and tune on some ...
Question about Cobra Radio Communications
ant light turn red whats the problem...i am using a brand new antenna your swr setting are off wack fix your swr After installing the antenna, follow these steps to adjust the standing wave ratio(SWR)
red ant light I recently bought a new cobra 29 nw ltd classic. Calibrated fine, swr is good, red ant light comes on when I key the mike. Receives good, transmits good. I drive a Kenworth T2000, ...
Question about Cobra Radio Communications
...red when you press the mike key. The other light indicates a bad SWR if internal circuits are properly aligned. If someone has turned the pot which sets the level at which the light comes on, it may ...
999 questions posted
Usually answered in minutes!
274 Questions
141 Questions
137 Questions
112 Questions
75 Questions