Question about Cobra Radio Communications
and i went to a radio check on the unit and it says that my rf power failed what would cause that to happen you may have burnt the diode that a variable controls or you messed with it and burnt it out
...do i put variable power in a cobra 29 go to www.cbtricks.com click on radios,go to alphabet listing for c the cobra then click on the top where it says radio mods and info and there is what you
...variable resistor for minimum resistance and it will let your radio have full output power. No cutting!!! Check it with an oscilloscope and watt meter, and check the frequency with a freq counter. ...
...variable power from J36. The problem with adding variable power and not switching the pot is that the wires not only have major loss, running to the pot. And two the stock potentiometer tend to burn ...
Question about Cobra Radio Communications
...power meter VR6 antenna warning light There is not pot for swr cal internally. I guess the cal knob broad range pot or variable resistor. Swr readings after user calibration knob on front of radio, ...
...variable power, wich will control the dead key, which is basically a varible swing kit. I run it just under 2 watts, just enoug to get a 125 watt dead key out of the amp. The amps swings over 920 ...
Question about Cobra Radio Communications
variable power so you can dim them or brighten them to your liking. Simply unsolder the two wires from the Dynamic knob and solder them together and either tape them off or use a small piece of shrink
...variable resistor, so the less resistance, the more modulation. So you want to turn the VR down. that will be more then enough. Hi, Appreciate the direct "Ask Me". To my knowledge, there are four ...
Question about Cobra Radio Communications
...a Superstar crt 240 cb radio tunned for 15W I want to put a switch for switchingbetween 3W-8W-15W Can I do this ? how ? thank you very much ! yes you can do this.its called a variable power switch
...if you need it to be variable,, use a transistor in place of the resistor.. there are no power connections to it, to cause a hum.. there must have been a wire you moved or not installed
277 questions posted
Usually answered in minutes!
980 Questions
141 Questions
137 Questions
112 Questions
75 Questions