Garmin iQue 3600 GPS Receiver "error messages power" Questions

Raymarine 41xx - Message "bearing pulse error" Have 41xx radar with 48" array, powers up and shows targets for 15 seconds than the array will stop spinning and a get a message :bearing pulse error". ...

...error messages that said the the file GPSview.arm920 couldn't be copied, but it was present on the computer. I also have an Acer Aspire One computer, and I get the same error messages. Both computers ...

error message. Also cannot turn off the device with Power button. The device stays On till battery runs off. Is there a solution to fix the device? Thanks Anna You'll have to do a hard reset. Push the

error message, on the pc or the 3100 when you press on button, press in reset but. , menu should come up. Select option with reset , press power button to select choice. update wince > update maps

...power cord goes from green to flashing red and we get an error message saying that the transducer is disconnected. You either have a fault in the head unit, connection to the transducer, broken wire ...

...power button and your device will perform some activites to recover from the above problem. Apparently this sequence will only work with the above error. I hope this assists other if they encounter ...

...unit down... Help.. BillW I had that error and when I did a restart (hold in the power button for 10-15 seconds to turn off then again for 10-15 seconds to turn on) the unit restarted fine. Try

...error, your probably not able to access it via a usb cable to your computer and if the computer cant see it, you cant fix it.. actually, you can fix it, but its a royal pain and i wouldnt recommend ...

...power button and your device will perform some activites to recover from the above problem. Apparently this sequence will only work with the above error. I hope this assists other if they encounter ...

...Power the unit up and let it come up with the error, then use the reset button. Might be hard to find since it's just a little hole with the word reset around it, using a paperclip push in the button ...