GE 25GT270 TV "print circuit" Questions

...of the television. Is there anything I can do? You burned out a resistor, capacitor or possibly a printed circuit trace on the solid state printed circuit board. This is going to take some ...

...for a while would just turn off and back on then it would work The problem is a bad "Digital A" printed circuit board, located on the main printed circuit

...intermittant vertical sweep circuit! It could be the vertical out put IC solder connections on the printed circuit board, or maybe the IC itself has poor connections between the IC and the contact ...

...the fault in its [AKB], Automatic Kin Bios circuit. During the fall there must have a break in the printed circuit board, especially on its LOT [Line Output Transformer] side. Just open the TV and ...

...me what parts i need to fix it or even go about fixing it a lot of times when a set is dropped the printed circuit board gets cracked, the only way to tell is to remove the back and printed circuit ...

...fitted around the neck of the picture tube. From it, there will be four wires going to the main printed circuit board, out of which, two will be thick, normally red and blue coloured, and the ...

...circuit board should I change or send in for repairs? definately there is a loose contact as you have ezplained. please check connector or some print loose or parts loose in power supply. if it is ok ...

...a very skilled work, and you must have through knoledge in electronics and expereince to work with printed circuit

...by a technican. One possible reason could be coolant from the picture tubes leaking down onto the printed circuit board causing this symptom which could end up destroying the circuit traces on that ...

...example, the caps in the same circuit will be marked C3xx. These are circuit designations that are printed on the board. Look for caps with values of either 47ufd or 100ufd. These are the most