radio [ Not installed.] There are two black wires on the left side of the case. One is soldered to a copper plate on the case, which also has a bare copper wire going to a copper coil.. The other goes
Question about Alpine Car Audio & Video
radio sounds good but its not too loud so i go to crank it up little bit its like my amp shut"s my deck off like short??? 3552 i hook jvc kd-sx9350 200 wat and installed alpine3552 amp did not use big
...are connected to the radio. if all is ok then check the inline fuse from the hot wire from the battery is not blown and the fuse on the amp is not blown.if so replace them. with the proper amp
radio don:t have rca jacks i have run the hot wire and the ground and the remote to the amp but it won;t turn on . You need to confirm that you have sufficient B+ and remote turn-on voltage. With your
...radio and attach the other end to your new one. Connect the antenna cable (the single wire with the big plug at the end) to your new head unit as well. If the speaker wires are separate from the ...
hot cable checked my speaker wires (inside and out of the box) and finally gave up and put it back in the box ready to go back. This problem occurred on any radio i put in my truck i tried 3 different
Question about JBL Car Audio & Video
wiring wrong?, what should i do?. If it helps... i dont have an equalizer (preamp) is directly to radio, my radio is a sony xplod cdx-gt100, the power wire is 4 gauge (same as the ground), i dont have
hot" that powers up the amp when the head unit is turned on, but don't know if it's a full 12 volts, and was wondering if I can put a jumper wire to see if it works. one more thing, I bypassed the amp
36 questions posted
Usually answered in minutes!
481 Questions
126 Questions
44 Questions
31 Questions
26 Questions