Kenwood KAC-X501F Car Audio Amplifier "bridge amp 2ohms" Questions

Ad

...2ohms the amp is 2ohm stable .the L7 is a 4ohm dual voice coil when wired in parallel it goes down to 2ohms and when wired in series it goes up to 8ohm load right now i have it wired in series at ...

Ad

...bridge my amp or not? what should i do with my subs? should it run in parallel or in series p.s. thanks to all the guys who answered my previous queries you've been very helpful thanks again the ...

Ad

Question about Pioneer Car Audio & Video

2 Answers

BRIDGE IS BURN OR MY 2 CHANNEL? PLEASE HELP From the specs this amp can only handle 4ohms when bridged but can handle 2ohms when it's not bridged Specifications Continuous Power (20Hz-20kHz, 0.04% THD

Question about Rockford Fosgate Car Audio & Video

1 Answer

...a JBL GTO 600.1 in bridge, in the manual say cant be bridge the amp, how much power is in bridge at 1 ohm, can be dangerus if i ruing bridge? it will over heat the amp posibly blow ...

Question about Bazooka Car Audio & Video

1 Answer

...when bridgeing an amplifier it always sees half of whatever load you have on it, so if you have a 4ohm speaker when it is bridged the amp will see 2ohms, so yes you can bridge the 4 ohm ...

Question about Kole audio Car Audio & Video

1 Answer

...bridge the subs to the amp the protect light comes on but the amp works fine when subs are not bridged is the amp able to handle two 4ohm subs bridged? Thanks Are you setting the bridge switch for ...

Question about Power Acoustik Car Audio & Video

3 Answers

bridge the amp then the volt meter on the dash goes down and the amp cuts off Hello munchisfun, I'd suspect that the amp is operating into too low of an impedance and going into protection. The 2200/2

Question about Lanzar Car Audio & Video

1 Answer

...thank you The impedence of the speakers does not match the amp operating impedence. This amplifier is made to run a 2ohms stereo stable which means 2ohms per channel or 4ohms

Question about DHD Car Audio & Video

2 Answers

2ohms. the amp is a DHD ntx3102 4 ch. question is am i better off bridging the amp for each speaker at 8 or 2 ohms? what is best? Your amplifier is 4 channel... and only 2 ohm stereo capable. You will

Question about Directed Electronics Car Audio & Video

1 Answer

...bridge it to youre amp for 1-2ohms continous power....make sure youre amp says continous power at 1-2ohms if it says in the manuel not stable it will just cut on and off at its peak because of over ...

Not finding what you are looking for?
Kenwood KAC-X501F Car Audio Amplifier Logo

17 questions posted

Ask a Question

Usually answered in minutes!

Top Kenwood Car Audio & Video Experts

Marvin
Marvin

Level 3 Expert

85231 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

The Knight
The Knight

Level 3 Expert

76287 Answers

Are you a Kenwood Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...