Kenwood XXV-03A Mono 25th Anniversary Power Amp Car Audio Amplifier "remove protect flashing car" Questions

...power input gets warm check the OHM resistance on your subs. do not go under the minimum OHM value. remove the power wire and retry again, if it does the same thing the amplifier needs repair. try: ...

Protection light flashes on and i get nothing when i turn on the ignition the amp will either blow the fuse or the protection light will flash then turn off and the amp will not power on. what does ...

...flashing and also the clip flash some times and protect led is On, the subwoofer doesnt make any sound so this happens when the car its on. When its off the protect and the power light always are on. ...

...a ohm meter, it should be more that 1, if not 2 ohms. With the wires from the speaker termanils removed and the amp off check the condinuity between the two terminals, there should be none...if ...

...protect light flashing together and there is no sound. I have never seen the amp flash these lights before. please help!!!! Thanks, Chris Does it do the same thing if you remove the RCA input and ...

...most likely causes for an amp to go into protection, is a short or ground on the output terminals. Remove the speaker wires and see if the amp powers up normally. Check the speaker wires and voice ...

...one at a time to locate a shorted wire or defective speaker. 4) Check all speaker connections. 5) Remove RCA inputs and see if the amp powers up properly. A shorted or grounded RCA cable can cause ...

...flashing I have a GM-X862 pioneed amp. It keeps fading in and out. The red light flashes on and off. All the connections seem tight and I checked the conductivity with a multimeter. Seemed ok, any ...

amp light on my MPR-M1000 keeps flashing HI,    Disconnect the speakers fist. then check the amplifier light flashing or not.  If not then then any of the speaker is faulty. If the

...car not running key in the ACC position there were no problems until the bass vibration triggered the flashing protection mode. Once removed from the vehicle, I looked the amp from top to bottom, and ...