Kenwood VR-305 "replace blown fuse onkyo tx" Questions

blown, i replaced it, blew again when i plugged the unit in. i disconnected the power board big wires, grey and green, and the fuse did not blow. i reconnected the wires and the fuse blew again. It is

fuse was blown. I replaced the fuse now the right channel has no audio and the left channel puts out the same distorted audio. When I remove the left channel fuse it reverts back to its origial state.

...blown internal fuses- replace and try again .... or failed thermal fuse in mains transformer. this is a workshop repair as it involves mains voltage that can kill :) stick your finger in your mouth ...

Reciever wont go on I get "Protect" Display on my reciever Your are running out of power !! you may have a blown fuse(s). I had the same thing and I replaced two blown fuses and OK now.

blown fuse on my receiver, the word protect keeps coming on ,unit looks very clean and dust free ,can,t see any bad wires or burnt circuit board , got any clues? My dear friend your audio amplifier IC

fuse that might've blown and be replaced? I took the cover off and can't locate one if there is one. Thanks, Wiseman777 Sounds as though something terminalhas happened to he power supply. If it is new

blown fuse inside the unit. Disconnect from power, let stand 20 minutes to make sure the high voltage caps are drained. Open and look for a fuse near where the electrical cord goes in. Remove and test

...another amplifier and if it works from there your onkyo must be in trouble. open the unit and check for any blown fuse, if found any replace it w/ the same value, do not replace fuses w/ higher

...blown fuse inside. triedthe reset(standby and video button) and no luck. ready to toss it in the dumpster. any ideas? Was this bought new? If so, take it back to the seller while you have full ...