...Power Supply. A small 5 amp power supply will help you. Their is no plug that goes Directly from a Mobile CB rado into a wall. You will need to plug a power supply into the wall, Then take the power ...
...POWER SUPPLY I NEED TO LOCATE ONE FOR THIS RADIO ALSO INEED A 3 PRONG 12 VOLT POWER SUPPLY CORD. Any electronics supply store should have what you need. Try searching online. RADIO SHACK should have ...
Question about Midland Radio Communications
...power supply. If your CB is strictly stock a good 3 amp power supply will be fine. But if you do any power or modulation mods on it then go up to a 5amp power supply. The negative wire on your CB ...
Question about Midland Radio Communications
...power supply for a laptop W/GPS. It causes major static continually. What kind of supressor should I use? with the GPS on, disconnect the antenna from the Cobra 21. if the noise from the GPS is ...
power supply. when i turn the power supply on the cb flases on then off. What causes this and can I fix it. Are you sure the power supply is good. Can you hook the radio up to a vehicle to verify it's
Question about Cobra Radio Communications
...power supply.The humming is not from the power supply, the other people that your talking to say that i have a hum when i key up and start talking. You need to replace your filter capacitors in your ...
Question about Midland Radio Communications
power supply: it broke into oscillation when drawing more than 150 mA at 13.8V. The 1001Z draws about 150 mA on Receive, and much more (but only about 900 mA) on Transmit. If using the 1001Z as a base
Question about Cobra Radio Communications
...power supply put 20+volts inti it, what could be the problom. Your power supply is providing 20 volts? THAT is the problem. This radio should be connected to a power supply capable of providing ...
...power supply and running high power on Cobra 200gtl.. When transmitting,on high power, the needle moves properly and output power is good for a few seconds then within 2 seconds the power drops off ...
...power supply outputs the correct voltage (@ 14v ) until I turn it on then it drops to @ 6v. The clue is that it happend when I keyed the mic. I'm wondering if the PLL is bad. The problem is with ...
57 questions posted
Usually answered in minutes!
14 Questions
12 Questions
8 Questions
4 Questions
3 Questions