help me the nipple end of tv where the cable antenna goes in had popped out what can i do to get back in If you are decent with soldering iron you can repair it yourself. Remove the back, and remove ...
What does the ic 406 and. The ps401 and 402 look like or where could I find them in my sony projection tv. The red light is blinking 8 times Ic 406 is the audio amp ic. It is on the signal board, that
My TV looks like it had permanent 3-D. Red Ghost My TV looks like it had permanent 3-D. Red Ghost Imagaes about a couple of inches to the right. Tried the flash focus and manual convergence to no ...
problem with picture on older 52" i have a panasonic 52" which was purchased in 1994 approx. recently after 30 minutes of viewing the picture jumps and is scrambled ./ does anyone out there know why ...
Question about Samsung Televison & Video
My 50 inch dlp makes a crackling and popping sound, then starts to fade out and eventually makes a loud beeping sound. how do i fix this? When the TV starts up it is fine for maybe an hour or so, then
My TV is showing up in 3D what could the problem be. 3D look picture in rear projection tv is due to failure of convergence output ICs that will be replaced to fix this problem. If you have no prior ...
...heating. After turning set off for about 5 mins then back on picture was normal. This happened about 5 times. The last time however the picture never came back. No picture or menu just the blue lines ...
Zenith No power. First, locate the horizontal output transistor. This is found very close to, or next to, the horizontal output transformer (also known as the flyback). The flyback should be on an ...
SD tech , you said you could give me start to finish instruction on replacing the convergence chips #STK-392-110. I have located the chips where you said they would be and i can solder but having some
322 questions posted
Usually answered in minutes!
627 Questions
462 Questions
520 Questions
406 Questions
457 Questions