Sony Grand WEGA KDF-42WE655 42" Rear Projection HDTV "driver lamp tv" Questions

Ad

Question about Sony Televison & Video

2 Answers

...Lamp Driver with a 1468798-16. The TV comes on, and I get a picture for about 30 seconds and then the picture/lamp goes out while the green light blinks. Then the picture/lamp comes back for about 30 ...

Ad

Question about Sony Televison & Video

1 Answer

...Lamp Driver Problem? Sony LCD TV? My LCD TV has been getting progressively worse - instead of turning on - it will give off a buzzing sound and go to standby mode. (without turning lamp etc on) For ...

Ad

...lamp driver or the lamp? If it does need the lamp driver, how do I replace it? Is there a manual? Any suggestions on where to purchase the parts? Thanks! 5 times blink code means Lamp Driver error ...

Question about Sony Televison & Video

2 Answers

...lamp driver problem on a sony grand wega 50" tv? Could be lamp, driver bd., or both. Probably $250 for driver replacement. THE LAMP DRIVER COST IS ABOUT $125 plus labor marbe $350 , avery tv shop has ...

Question about Sony Televison & Video

2 Answers

...lamp driver (ballast) problem. remove lamp and check the connections of the lamp driver and the lamp itself.Connections may look burned.if they do replace that part (lamp or lamp driver). If the lamp ...

Question about Sony Televison & Video

1 Answer

...when the tv goes into shutdown because the lamp driver doesnt turn on the lamp. sometimes the lamp driver or ballast can be the problem but the lamp is the easiet thing ti check first. good ...

...lamp driver(ballast) are ok or they look bit burned.Also the lamp should always be replaced first especially if is two years old or more. Check to see how many times the error indicator flashes.If it ...

...Lamp enable line at connector J14 pin 6 on the Engine Driver PCB switches to 5 volts after turn on but does not go back to 0-volts (low) after 5 seconds, 12 and 5 volt supplies are good. Suspect the ...

Question about Sony Televison & Video

2 Answers

...Lamp enable line at connector J14 pin 6 on the Engine Driver PCB switches to 5 volts after turn on but does not go back to 0-volts (low) after 5 seconds, 12 and 5 volt supplies are good. Suspect the ...

Question about Sony Televison & Video

1 Answer

...cover snaps off, using screw driver open lamp door, unscrew lamp, pull out with handle, make sure lamp is cool. Replace, follow onscreen display to reset lamp hours. Use remote to enter

Not finding what you are looking for?
Sony Grand WEGA KDF-42WE655 42" Rear Projection HDTV Logo

1,050 questions posted

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76204 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1691 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...