...Lamp Driver with a 1468798-16. The TV comes on, and I get a picture for about 30 seconds and then the picture/lamp goes out while the green light blinks. Then the picture/lamp comes back for about 30 ...
...lamp driver. Total bulb hours used 5698. Original factory installed bulb, never been replaced. Sony techs say it needs a new lamp or the power supply box needs to be replaced. I am also getting ...
Question about Sony Televison & Video
...lamp driver or the lamp? If it does need the lamp driver, how do I replace it? Is there a manual? Any suggestions on where to purchase the parts? Thanks! 5 times blink code means Lamp Driver error ...
...when the tv goes into shutdown because the lamp driver doesnt turn on the lamp. sometimes the lamp driver or ballast can be the problem but the lamp is the easiet thing ti check first. good ...
Question about Sony Televison & Video
lamp driver error, which is possibly related to your lamp failure. You may have to replace the lamp driver or "ballast" to correct this problem. The 6 flash is a power supply problem and more serious,
...Lamp enable line at connector J14 pin 6 on the Engine Driver PCB switches to 5 volts after turn on but does not go back to 0-volts (low) after 5 seconds, 12 and 5 volt supplies are good. Suspect the ...
...lamp driver problem on a sony grand wega 50" tv? Could be lamp, driver bd., or both. Probably $250 for driver replacement. THE LAMP DRIVER COST IS ABOUT $125 plus labor marbe $350 , avery tv shop has ...
...cover snaps off, using screw driver open lamp door, unscrew lamp, pull out with handle, make sure lamp is cool. Replace, follow onscreen display to reset lamp hours. Use remote to enter
...lamp driver (ballast) problem. remove lamp and check the connections of the lamp driver and the lamp itself.Connections may look burned.if they do replace that part (lamp or lamp driver). If the lamp ...
...Lamp driver error". The probable cause listed is, "lamp driver faulty". Its also possible that the internal antenna used to detect the presence of high voltage has become mis-positioned. The lamp ...
407 questions posted
Usually answered in minutes!
1,430 Questions
874 Questions
716 Questions
647 Questions
601 Questions