light on the motherboard is on If the green light on the Mobo is on, more than likely your processor is dead, If it post's ,then listen for beeps, which could indicate a problem with ram or video card
...mobo video o/p - same results. i pulled all of the i/o power and data cables - same results. nothing smells burnt - no surge or lightning strikes - just won't reboot??? any suggestions? Based on your ...
...mobo...since it power up and you see the light indicator are processing ..to be sure ..when you turn on the pc..does the light for HDD is processing like blinking green/blue..if does..try to connect ...
...ram memory hasn't come unseated from the mobo. If you are using an above board video card also check that it is properly seated as well. The clicking noise from the PSU is kinda perplexing
Question about E-Machines Computers & Internet
...video port may be 15 pin VGA while your screen uses a DVI cable. You can use a VGA to DVI adapter to make the connection. Try this and it should work...When you are powering up, power up in safe mode ...
Question about Dell Computers & Internet
...MoBo light is steady amber in both cases. Does it mean the PSU Try another monitor or video card if it has a separate video card. If it does have a separate video card remove it and attach monitor ...
...mobo but maybe not to the start switch connections? Try sub hard drive first to prove a point Unplug your PC and then open it up and unplug the Power Supply Unit from the Motherboard carefully... If ...
Question about E-Machines Computers & Internet
mobo appear to have die. I try to upgrade my memory from 512MB to 1GB. These are expensive Rambus memory. The type are Non-ECC. I got by mistake, ECC type. But I install them anyway because I was told
Question about E-Machines Computers & Internet
video card, the ribbon cables - it seemed to be everywhere. Well I know I didn't pour Ragu Sauce in my computer, so I did some research and discovered Dell had a big problem with capacitors popping. I
...mobo. Unlpugged the power cord and opened the side panel, inserted the card on my table put it back together plugged it back up try to start and nothing won't start up. Reopened it took the card out ...
5,283 questions posted
Usually answered in minutes!
345 Questions
167 Questions
141 Questions
87 Questions