Evolis Pebble 4. For each card printed, a white thin streak appears. This streak cuts through the entire card. Try cleaning your printer first using the Evolis A5011 Cleaning Kit. If the line is solid
...Evolis Pebble 4 to print card, i wish to let the printer flip the card itself and print at the back of the card. So i first set the duplex of the printer to vbPRDPVertical on VB6, and then i issue a ...
...Evolis Pebble 4 printer. I am trying to print out cards from the Pebble 4, but the machine is not pulling the cards from the card holding tray. Because the cards are not being pulled from the tray, ...
...Evolis pebble printer 4, which is installed properly but we start printing, it does listen the command. Second LED is ON permanently. Can u tell us what is the problem? When we give print command? ...
Question about NCR Office Equipment & Supplies
Evolis Pebble 4 and I have problem with printing the ribbon light is always ON and it does not print with YMCKO, but when I change to black ribbon K it prints. What is the problem. It sounds like your
...Evolis Pebble 4 and ribbon hologram. The problem is that the printing of the card goes bad. The surface of the card is not completely covered by the tape hologrma Thanks Ckeck for proper ribbon ...
Question about NCR Office Equipment & Supplies
Evolis Pebble 3 says feeder error but there is not. It won't pick up a card when you try to print but when you press the push button it feeds out a card without printing. It will alos not print a test
Question about NCR Office Equipment & Supplies
Evolis Pebble 4 with a gold monochrome ribbon. Printing on pre printed blank cards. The print is not complete, almost as if there is not enough pressure on the card as it is printed. All the letters ...
Question about NCR Office Equipment & Supplies
Pebble 4 card printer and the ribbon breaks after each card is printed. I have a Pebble 4 card printer and the ribbon breaks after each card is printed. the card are not being fed when printing a test
driver on evolis site. 2.Check whether both side printing is selected in driver 3.Check for Varnish sensitivity setting in Graphics setting it should be default. 4.Read the ribbon type with Rr command
30 questions posted
Usually answered in minutes!
1 Questions
0 Questions
