...standby light. do you know what the pix look like be for it whent dead? some time bad solder can do this. in the center of the board thear is fuse that go bad because of bad solder on stk 392-120 or ...
Question about Mitsubishi Televison & Video
light to stop,then turn on the TV.The hard part will be removing the board from the TV(lots of screws and connectors,takes time) You must do some checks first:LED does not stop blinking after plug in.
light flashes 3 times then pause & flashes 3 times again. What is wrong??? the reason the tv flashes its l.e.d is to tell you there is a major fault in the main circuit board (pcb) and needs to be
...standby button untill a light appears. in sequence up down left right menu ok press the buttons on the front of the box wait 60 seconds and the normal red light will appear turn on box and there you ...
...standby light or the green light turning on and then going off in few seconds, that is a sign that there is a problem inside of the unit. When the television gives off signs as this,it could be as a ...
...light will come on briefly. There is a 57V supply on a resistor directly beside the largest ribbon cable on the swp board side. With the ribbon cables connected, it reads 1.5mv on one side and 23V on ...
846 questions posted
Usually answered in minutes!
2,410 Questions
1,124 Questions
809 Questions
510 Questions
405 Questions