Samsung TXM3298HF 32" TV "zero working remote control" Questions

...Remote Control Press 1.3.6.9 and 0 (Zero) Close Disk Tray Power Off or Turn Player On Open The Disk Tray (Leave Open) On Remote Control Press Clear On Remote Control Press 1.3.6.9 and 0 (Zero) Close ...

...control won't work but if i hold volume button up with fingure it will stay till fingure is there or else it goes dow to zero. ca u help picture is fine just volume and remote controll won't ...

...zero. If I try to turn it up on the remote or tv it automatically goes to zero There is a damaged [leaky] transistor at the electronic volume control section circuit. Contact any service technician. ...

...signal pin should have inverted digital data (about 4.5 to 0). If you measure the signal pin and it is near zero volts, replace the receiver. If the signal pin is around 4.5 volts, replace the

...remote control (RCR4383) that seems to require that all TVs have a code that starts with 1 and has four digits. None of the magnavox codes that are in its documentation work with the 27MS343S. Is ...

...working manually but after checking menu for block accidently FPA locked not can't turn on tv at all. You must have its remote control to unlock this TV.  Try to make your remote control ...

...The set won't say so, but the lock will be unlocked Hold down the 0 (zero) button on the remote and the VOLUME DOWN button on the TV itself at the same time for at least 4 seconds. The set ...

zero) button on the remote and the VOLUME DOWN button on the TV itself at the same time for at least 4 seconds. The set won't say so, but the lock will be unlocked 3.     

...working it is stuck on channel 3 and stays there and need it to go on output in front and can't watch any channels with direct tv satalite very difficult lost remote and need code this tv and can't ...

...bypassed by holding the zero key on the original remote hand unit, and at the sane time holding down the volume down on the front of the TV set. This should reset the oide so you can enter a new