Samsung HCN436W 43" Rear Projection Television "140" Questions

hav a sony kp 61hs30 need horz output. number on part MB12-140. is this a regular trans Correct number is 1MB12-140 (Q8038) on D board of Sony KP-61HS30, its part number is as follows.. Q8038... 8-729

If 40percent of a number is 56, what was the original number Hi, 140 Break it down as such: 40% of X# is 54 40% x X# = 54 0.40 x X# = 54 isolate X# by dividing 0.40 on each side: (0.40 x X#/0.40) = 54

...Screen is completely dark. Lamp LED flashes 2X every 5 seconds, Power LED flashes GREEN for 140 seconds then flashes RED. Check the ballast if no picture, audio may be present. Screen is ...

...SHP70 (This number is right at the top of the bulb/lamp, where the wires connect) Housing Model: 140-1027 (This is also known as the Ballast which houses the bulb/lamp) Now, I've managed to locate ...

PT-47WX53 power light blinks five times Five blinks means short on the 140 volt line inside the set. How much skill do you have? You will need a Ohm meter----to check for a short. Clearly I do not ...

...come on. If your power light blinks three times, that is an indication that there is a short on the 140 VDC line. This voltage feeds your Horizontal Output Transformer or HOT. You will need a DVM to ...

...at that time). Today it failed to start and gives a single flash code... I understand this is the +140 section, but I cannot identify that on either circuit board, and I see no visible damage. Any ...

My Hitachi c2514t picture is distorted it bends out at the top and bottom. how do I sort it out £140 it cost me to get a new convergence module fitted. Common fault with rear projections

probably a bad high voltage transformer and horizontal output transistor. check b+ should be around 140 v. not an easy repair

no picture If this a sanyo DLP, Bulb is in the back near the bottom and will cost $140-240 depending on your model