Samsung HC-P4241W 42" Rear Projection HDTV-Ready Television "green shadows panasonic tv" Questions

...Panasonic PT47WX54J from Costco is showing a red shadow behind words and pictures. I unplugged it from the outlet, to see if that would work, it did, but shortly after it went back. Please advise, ...

Green, Blue curve upwards and cast shadows The scrolling banner scrolls on bottom normally but the words starts separating upwards and curving along about 3" above the normal scrolling and then starts

...green or pink shadows, then it can be a problem with the anti polarization panel placed on top of the LCD. Similar spots (colored shadows) may be caused by a problem with the light engine, in that ...

...green aspect This tv have a problems known as a convergence problems,it dead.Tv have colors lines R,G,B mis alignments,have colors shadows picture or 3D picture look alike?The tv convergence board ...

Green tint only on left hand side towards the middle of the screen Tv have a problems known as a convergence problems,it dead.The tv have colors lines R,G,B mis alignments,have colors shadows pictures

panasonic raer projecter now the image have a blue and yellow shadow and also the words have a shadow some body told me the guns need to reline i dont know what to do can yoy help me please seems like

...pink and green shadows around pictures and text Stk392-110 Convergence IC's bad.....requires chassis pull & good soldering ability.......................T. change stk's and check for open ...

...green shadows on the top as well. Do you have any suggestion of what it is.Thank you,Buchanan the convergence ic's are breaking down and require replacement should cost under $ 250 depending on your ...

...green glow appeared one day. It is approximately 8 inches to the left and 12 inches above the center of the TV and about 3-4 inches wide. There are also some 'shadows' that appear in shading areas ...

...green shadows, words on screen are jumbled. you need new convergence chips, there are 2, part number stk 392-110, also you must check for burnt resistors, if you don't have very good soldering skills ...