Toshiba TheaterWide 52HM84 52" Rear Projection HDTV-Ready Television "video replace running light bulb" Questions

...REPLACE IT HOW MANY SCREWS IN BACK DO I NEED TO REMOVE TO GET TO LAMP AND APPROXIMATELY HOW LONG SHOULD PUTTING NEW LMP IN TAKE AND DO U HAVE ANY VIDEOS TO SHOW ME You must locate your bulb (usually ...

...REPLACE THANK YOU VERY MUCH BOND Hello Mr. Bond. I believe that you have a rear projection TV where the light from a powerful halogen light bulb is focused onto a micro-prism viewing screen through a ...

...running and then go out while the lights blink on and off. I have replaced the bulb, but that did not take care of the problem I have the same problem. It flashes ten times when booting up. Once it ...

replace a 680uF cap with a 500uF or a 1000uF (unless you are SURE it's only doing supply output ripple filtering, and even then, you should go OVER, not under the uF rating). Most of the caps that

...and have run into same thing and i had bridged a solder connection. I hope this helps thanks doctor ...

video and light circuitry? Replace Ballast Board it is what turns Lamp on! Call Encompass for Part 1-800-638-3328 . There are a couple of caps on the main power supply board that might be bad. The way

LIGHT COMES ON IN THE FRONT OF THE TV. iM NOT SURE IF ITS THE COLOR WHEEL OR MAYBE THE BULB OR SOMETHING ELSE?? Here is what I would do if I was you. Remove the lamp---it is customer removable---- The

...replace it immediately. Second consult your user manual and verify the lamp and lamp cover are installed properly. Most Rear-Projection TVs have warning light which notify you when there are lamp ...

...video), orange blinks 36 times, code 32; comes on after atleast 15 min., stays on anywhere from 10min to 2 days, starts again, ad nausium !! The only thing that could cause the yellow light to blink ...

...replace the bulb once, but I do not remember this issue before. The TV will turn on normally, but after a few minutes, will go out. The standby light will blink repeatedly. Then it will come back on ...