Question about Panasonic Televison & Video
...set. It is because the timing unit for the degaussing coil has changed over time and is staying on just a little to long causing the fuse to blow. A technician will put a 7 amp fuse in as a ...
...fuse is blown, when I trace the power cord to the circuit card, I can't locate the fuse. If this set has a fuse, where is it located? all sets must have rated fuse for protection. some units now ...
...unit is dead set without an standby LED light and your outlet is live.1.Power cord - check the cord it might be opened (no continuity).This is due to frequent bending,pulling. 2. Power switch - check ...
...set and locate the end of the cord which is soldered in the circuit board. beside it is the fuse holder replace it. Make sure to unplug the unit while doing the replacement to avoid electrical
...unit has to be replaced but none available but will notify me if and when it is. I now have an expensive TV set that I cannot use and uncertain about its reliability. I have surge protection on all ...
...power but unit has none is there a breaker or somthing else inside there is a fuse inside your set! but might not just be problem of it! check for it! what size is the fuse, do you know? I cant read ...
Question about Fisher Televison & Video
...unit turned off on it's own. I unpluged the set and let it cool down. I pluged it back in and it did not work. I checked the internal fuse with a multi-meter. It tested good. The circuit boards were ...
...unit power requirements. Look for number of amps draw. Let's say you read "2 A". Now, depending on where in the circuit this fuse is, your fuse size will be no more than two amperes (sometimes ...
...no noises, nothing on the screen. Probably dead or expensive to fix? Check the main A/C fuse. These sets are famous for blowing the fuse. It is usually a 6.3 amp. Look at fuse to confirm size. Thanks ...
97 questions posted
Usually answered in minutes!
405 Questions
364 Questions
299 Questions
263 Questions
243 Questions